Being in a situation where the HP printer starts acting up is frustrating.
It can hinder how your printing experience unfolds along with the results. This is why it’s important to keep tabs on what is going on with the HP printer throughout the process.
One problem that can arise is when the HP printer is stuck on the printing alignment page.
If the HP printer is stuck on the printing alignment page, the most common issue is a faulty ink cartridge. To fix the issue, open the printer, inspect the ink cartridges’ level, and replace anything that’s damaged. Once done, complete a hard reset to start the printer again.
This issue tends to happen when the ink cartridge is giving problems.
You will always want to keep an eye on the ink cartridges in the printer. When the levels start dropping, it’s common for the printing process to come to a halt.
You may attempt to run it to the last drop but it will likely stop well before that point.
This article is going to look at how to fix an HP printer that is stuck on printing the alignment page.
How To Repair HP Printer Stuck On Printing Alignment Page
1. Open The Printer
When the HP printer is stuck on scanning the alignment page, it’s important to see what’s going on internally.
The root cause is going to be the ink cartridge.
This means the best course of action is to take out the paper and then open the printer. When you do this, you are going to get a proper look at why the process is getting stuck and what to do about it.
Take your time to look at every part of the process.
This not only includes the ink cartridges in the HP printer but also the tray and its surrounding elements. You should have a good grasp on all of this to make sure you are in control of what you are using.
2. Inspect And Change The Ink Cartridges
Now it is time to look at the crux of the matter.
In general, when the ink cartridges in an HP printer begin to drop in ink, this is when the problem arises.
The HP printer starts acting up as it believes there is not enough ink to move forward with the printing. A lot of people will assume this is only going to happen when the cartridge is empty but it can happen before.
You will want to take out each ink cartridge and make sure nothing is empty. You can also test the ink cartridge levels while the cartridge is in the printer.
You will want to replace any ink cartridge that is damaged and/or empty.
3. Do A Hard Reset
Now, you are going to begin with a hard reset.
The emphasis is to make sure you are doing a hard reset as it will allow the ink cartridges to get scanned again by the printer. If you don’t do this, the HP printer might not pick up on the changes that have been made.
Just complete the hard reset and let the printer go through the process again.
When you attempt to use the printer now, it is going to work without getting stuck.
4. Re-Test The Printer
For the most part, the HP printer is going to be fully functional at this point.
It is recommended to always inspect each element in the printer to make sure nothing else is damaged. This also includes going through the printer’s settings to see whether or not changes can be made.
If you can make changes then that is a good option to bet on as a user.
You will want to do all of this right now rather than wait any longer.
Take your time to re-test the printer and make sure it is set in a way where it will work properly. This is how you are going to get the results that you are hoping for.
Final Thoughts
It’s important to think about these details when the HP printer is stuck on printing the alignment page.
If the HP printer is stuck on printing the alignment page, it’s time to remove the paper, open the printer, and inspect the ink cartridges. This includes inspecting their levels and swapping out the empty/damaged ones. Once done, complete a hard reset to test the printer again.
At this point, the HP printer should be back to how it was before the ink cartridges saw their levels drop or got damaged.
It is common for this problem to occur and the best course of action is to focus on changing the paper as soon as possible. This is how you are going to get the printer to work as intended.
Here’s More On Printers:
